| View previous topic :: View next topic |
| Author |
Message |
kcp
Joined: 08 Feb 2010
Posts: 2
|
 Posted: Mon Feb 08, 2010 7:29 pm Post subject: Mira 915B runs too hot |
 |
|
| Applied flow and temperature service packs about six months ago. Gave the shower (about 20 years old) a new lease of life. Set it so that comfortable shower temperature was around the '5' setting and worked fine. Over the last few weeks that comfortable shower temperature has been falling so that now it is a critical setting between '0' and '1' ie zero too cold '1' too hot. Is it likely that there is another part that has failed? If so which? Or should I try to reset the temperature again? Hope you can help. |
|
| Back to top |
|
 |
coulter1
Site Admin
Joined: 13 Jan 2010
Posts: 1821
|
| Posted: Wed Feb 10, 2010 2:02 pm Post subject: |
|
|
Something is sticking inside, suggest you stri thermal cartridge down again, clean thoroughly and reassemble using silicon grease. If this does not work then you may require a new thermostatic cartridge.
Alastair |
|
| Back to top |
|
|
kcp
Joined: 08 Feb 2010
Posts: 2
|
| Posted: Fri Feb 12, 2010 7:04 pm Post subject: |
|
|
Alastair
Thanks I'll try that.
Kevin |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
